sleepingking

I am setting a new modem. and try to set my port forwarding. Before I can access to change my port forwarding, I was asked to enter my Ip address on LAN Client page to enter this setup. So when I click on LAN clients, I was asked to key in two things 1. New IP address: 2. Host Name: I am not sure what to put in here. When i run my ipconfig in dos, there is one IP ADDRESS and one Default Gateway. So which one should i key in for the first item? What to key in for Host Name? Where to get it from? Appreciate advise here. Thanks

Neither 192.168.0.1 nor 192.168.1.1 is working. Anyway, my office router is using cisco Without setting the Port Forwarding, I tried to Bit Tornado and also failed Failure reason is as below Problem connecting to tracker <urlopen error(10600,'operation timeout')> Any idea why is this happen?

Thanks for the reply ! Dear Shug, Pls advise as below: 1. After putting 50000 to port start and 60000 to port end, do i need to put anyting for Destination port map? or the system will select a port for you btw 50000-60000? 2. I cant access to router configuration with http://192.168.1.1 in my office pc. Any other way could access to it? 3. You said make sure windows firewall is disabled. So I go to right click My Network Places, properties, double click Local area Connection status, properties, Internet Protocol (TCP/IP), then click advanced, then uncheck Internet connection firewall. Am I considered done? Thanks in advanced

1. Running Window ME 2. 512K RM66 monthly without modem 3. Not done any yet 5. Speed Test Results Your connection rating is: [Test Home | Re-Test] Compare to your ISP or other providers Your connection is: 294 Kbps (about 0.3 Mbps) You downloaded at: 36 KB/s Your TRuSPEED