aeallison Posted May 25, 2009 CID Share Posted May 25, 2009 Hi all, Is there any way to test the signal strength of the WB dish? Like with any typical satellite receiver you can usually access some menu that will show your signal strength, sometimes used to realign your dish. I have installed hundreds of sat. systems through the years and have always been able to fine tune a dish this way. When my WB system was installed the installer never once used any device; or web site, or anything/method to fine tune my dish from the recommended presets for my location. Is this common practice? Link to comment Share on other sites More sharing options...
zalternate Posted May 25, 2009 CID Share Posted May 25, 2009 To point the dish, he should of had a small square box that tells him what satellite the dish is pointed at and the fine tuning is done with it. Otherwise to get system alignment stats, you have to call WildBlue and have them tell you your alignment strength(SVT numbers). Since the modem is a dumb piece of equipment with no end user interface, just an interface via WildBlue support. Or if you are friends with an installer, he can get you the numbers. The Hughesnet modem has a user interface that gives all sorts of information. Link to comment Share on other sites More sharing options...
micwa1 Posted September 22, 2009 CID Share Posted September 22, 2009 Wildblue has recently released a user-tool that does show "signal strength" but probably not that you can understand. Check it out at: www.wildblue.com/pulse Link to comment Share on other sites More sharing options...
Recommended Posts