granpa

Yep, that's it!

I have found the trick to less ink is not to shut the printer off, it charges the system every time you start it up and as long as I use it once a week I don't need to clean the heads.

Epson printers are a little tough to refill since the cartridges have a chip. It can be done on many by injecting the ink into the cartridge but you will also need a chip reseter to show that it is full again. The first mixing of ink can cause problems if you don't run enough through to flush the original ink out since the print head is in the printer very small and plug easily.

Reading the story I would shake his hand and thank him to play it down as he seems to want as any normal person might do. We all have our own way of giving recognition, your out there buddy.

I have 2 of them, made by Bostich, and I say the same thing when one of them jams.

Your stacks of wood would probably fall over.

Well it's 9 degrees outside, 45 in the wood shop (not fully insulated), 75 where I'm sitting, my propane tank is full and I haven't lit the furnace pilot yet.

Not bad, reminds me of my first dirt bike, got it in mid December and had 1,000 miles on it by February, rode every day that winter (1972-73) no snow & no snowmobiles. Yesterday I got my Gravely out , hooked up the trailer, loaded the chainsaw and cut 2 cord by 11, no snow, different ride, no freeze-ups, air cooled. Trying for 3 loads today, it's now 6 degrees out and doing the just before sunrise drop. .

I think Roco might be a tad old to be "Mod", or has probably forgotten more than most of you have experienced, but that would probably make him a good choice. So Roco here we are

Really doesn't matter if the water is off or on. I usually try to have the line open slightly on the frozen side. Indirect heat is the only way since it probably has plastic line. Some type of heater is needed and it will take several hours. Removing a section of skirting is good but with a salamander I would run the heat through some larger pipe to keep the flame away. Avoid aiming the end of that pipe directly on something combustible. If you have a idea about where the freeze point is then that is where you aim if possible. Sorry if this information is too late. The extreme way would be hook on and move further south.

A larger house usually means a larger heating and AC system so a larger allotment would need be purchased to the size. Kind of like the ones on Hughes complaining because their trying to run the larger demand on the smaller plan and getting punished for it. But then how can someone use all those large rooms in a big house, and at the same time. A dog usually gets a one room home, sometime insulated, and you never hear them complain unless you forgot to do something required of you when you have a dog.

Just set up a FAP like Hughes has. When you have used over your quota you get throttled back so the decision still is yours, air conditioning or refrigerator, hmm..what do I need the most.

You could do it faster if you only use one sentence in your replies, it usually takes you 5 to 10 to get your point across with all the color you add.

I would tend to think email sent to you could be considered HOTMAIL

My Linksys experience Have a copy of the original version handy. If you have a computer that has had no association with the router use it. Turn the router on and press the reset and hold for 30 seconds and then power the computer off and next the router. Now re-power the router and once up the computer. See if you can enter into web setup using the router's address. If it doesn't seem to work try the reset again. I have had some act funny and some I have not been able to get back into once I have disabled the DHCP. The ones I could never get back into I have junked. Hope this helps.

Router firmware most recent and also the wireless card?? http://shop2.outpost.com/product/3635275

Welcome, if you didn't feel welcome before, your welcome to stay in phoenix as long as you want, thanks for staying there but

tdawnaz = irish girl - (ir+y) = i shy girl

I'd like one that has braille running across the screen, or maybe just one side

So then is this true, ADSL= Another Digital Slow Lane

I had done some research on this and many will work but what you need to remember is that you will need to use the LNB's and Transmitter's used by Hughes. Also many larger dishes I found are cross polar which means your current transponder must be horizontal and vertical and the feed set to that. I did have a .98 dish (early cross pol model) that I purchased and worked very well but my upgrade from the 4000 to the DW7000 changed me to a Horizontal & Horizontal transponder so my dish became useless for me and I sold it. But the .74 seemed to work extremely well since I was now using the widest part of the dish for both send and receive.

Here is more information on the VPN and static IP. http://www.dslreports.com/faq/13545 I don't know if you have done any research here but there are very knowledgeable people here the have been with 2-way since existence and there are some installers that post also. Be sure to sign up (also free ) since answers come more frequent if known your serious.

Run these apps and then check. Ad-Aware 2007 Free http://www.lavasoft.com/products/ad_aware_free.php Spybot - Search & Destroy http://www.spybot.info/en/index.html ewido (online scan) http://www.ewido.net/en/

I was thinking of something like this http://theyreourchildren.blogspot.com/2007/11/mission-monday-angel-tree.html but I don't think it can be found everywhere.Various organizations may do this in your area.

These guys have http://www.unwiredadventures.com/unwire/2005/12/defcon_wifi_sho.html